The Mineraluxe Three Month Bromine System has everything that you need to maintain a healthy and perfectly balanced spa. It easily saves you time and frustration spent on proper balancing, and does not cost very much more than traditional spa chemical balancing. Fall in love with your hot tub all over again!
START UP – EVERY 3 MONTHS
- At fresh fill, or every 3 months, add 2 Mineraluxe Cubes and one Mineraluxe Oxygen packet.
- Bring in a sample to Aqua-Tech to test and properly balance the water. This includes balancing the Total Alkalinity, pH, and Calcium Hardness.
- Add your sanitizer – 4 tablespoons of Mineraluxe Bromine Granules or Chlorine Granules per 800 liters of water (as well as bromine tabs or chlorine tabs).
- Tablets help maintain the sanitizer level in the water
- Granules give you an instant boost and help the tablets keep the sanitizer between 3-5 ppm.
WEEKLY
- Test bromine/chlorine levels and adjust tablet dose.
- Add 1 Mineraluxe Cube and 1 Mineraluxe Oxygen packet with the pump running and the cover off for at least 15 minutes!
- Rinse pleated filter or replace MicroClean filter if needed.
- Test and adjust Total Alkalinity and pH if needed.
- PRO TIP: don’t have time for this step? Bring in a sample to Aqua-Tech for a professional water analysis and we’ll do the work for you
BEFORE EACH USE
- Test bromine/chlorine levels, if low (less than 3 ppm) add 2 teaspoons of Mineraluxe Brominating Granules/Chlorinating Granules per 1500 liters of water, wait 15 minutes, then use the spa.
- PRO TIP: After a spa party, add Mineraluxe Granules as well, this will remove any organics and prevent the sanitizer from dropping below 3-5 ppm.
EVERY 3 MONTHS – DRAIN & REFILL SPA
- Before draining & refilling spa – remove filter and clean using Mineraluxe Filter Revive.
- Add Mineraluxe Cleanse & Drain with pump on. Circulate water for 15 minutes. Shut pump off and completely drain water according to manufacturers recommendations.
MINERALUXE IN WINTER
- Since our winters are long and cold, we cannot drain and refill every 3 months during this time.
- Drain and refill at the last possible moment in the fall where temps will allow you to (usually late October early November).
- Start your first Mineraluxe Kit as usual.
- Start your 2nd Mineraluxe 3-Month Kit once the first 3 months have been used up and do another 3 months of Mineraluxe care.
- At the end of 6 months in the Spring when the weather allows, we will drain the spa using Mineraluxe Cleanse & Drain and start fresh for Spring!
If you have any questions or concerns, feel free to reach out to the water lab at watertesting@aqua-tech.ca
If you would like to purchase Mineraluxe today, the link is listed below…
