The salt output lights are blinking green. They are usually steady. Is this a concern. There seems to be no other problem.
The salt level is good, water temperature is 77, cleaned the cell last night for 30 mins doesn’t seem dirty. It’s our fourth year with this pool and equipment
You installed a new Pentair system this week as the old system went down. The setting was set to 20%, but due to the rain and the old system not producing chlorine, I moved it up to 40%. I checked last night and the chlorine was now up a little too high so I tried… Read More»
It is important to inspect and clean your salt cell regularly. Ensure you are chemically cleaning it as required to extend the life of the cell. Remove the cell by loosening the unions to release. Flush the cell using a garden hose and spray nozzle attachment to remove and loose or excessive debris Pour… Read More»
If you have a Dig-36 or Mineral Springs Digital Saltwater Chlorinator, one of the most common errors is a ‘Low Amps’ message. This is typically a sign that the cell and cell cable have or are close to expiring. Here are the steps to check the salt cell functionality: Phase 1: CHEMICALLY clean the cell… Read More»
I have a salt generator that you guys installed, the current level of salt is 3300 ppm and the generator isnt coming on to produce chlorine. I have tried upping the cell power and percentage and it still isnt producing chlorine I am wondering if i need to reset it or reprogram it the pool… Read More»