heat not staying on new 2018 Optima

we just picked up a new 2018 Sundance 880 Optima last week and the first time we used it the temperature started at 105 but dropped to 100 and would not come up any higher – any ideas on how we can maintain a set temp of 104? thanks!

Temperature over ride

How do I over ride the temperature Setting so that I can get 105 or 106F?

Sundance Hot tub

My Ozonator light is always on, is this an indication there is a problem? Is there someway of finding out what it could be?

OH code

I bought a plug ‘n play hot tub second hand – a dream maker spa X-400. It keeps overheating with OH code. I had heat sensors checked, changed the filter and it still overheats. The company who tested the heat sensors told me this is normal for a plug ‘n play hot tub to overheat… Read More»

Pool draining

Dawn has an indoor spa and was wondering if she should just drain it for the summer time as it gets really hot in the room where the spa is. She was also wanting additional information on any products that she may need to purchase to do so.

Flo

I have a 2006 Jacuzzi 485. I’m getting a FLo code. I had to replace the circulation pump a couple months ago. Hot tub was working great. Then I get this flo code. I have replaced the filter and flow switch. And still getting the Flo code. If I turn the Circultuon pump off it… Read More»

Hot Tub FL1 Error Code

Hi, I’m getting repeated FL1 error codes on my Hawthorne Sundance hot tub. Sometimes cleared by powering down then up, sometimes cleared by filling the tub to max recommended. When I clear it the hot tub will run until the water is re-heated, then will come back. Can’t find leak in system. How do I… Read More»

Bad Board

I have a 2010 QCA GT-289 hot tub. Pump 1 runs almost continually, and pump 2 does not turn on, though I can hear the relay click when I press the button for it. I’ve plugged pump 2 into pump 1’s spot and it does work. The 20 Amp fuse was blown and I replaced… Read More»

FL1 Code

My Pump 1 and 2 are both working, but still getting the FL1 code and no heat. I tried the hose trick, and some bubbles did come out of the footbed of the spa. Cleaned and removed filter. Tried cutting power from the breaker. Water level is good. At this point do you think it… Read More»

2007 Diamondback Spa

Received FLO error and wasn’t heating after several months working fine following refill. Noticed that Jets 1 aren’t blowing at all however lower larger jet near floor blowing normal when on and now heating. Jets 2 working normal. Ideas on areas to start checking first?