Air vintake

I am getting bubbles out of the jets and the pump reservoir will not fill completely When I open the valve at the top of the filter bursts of air come out This stops the bubbles at the jets but the pump still does not completely fill

POOL FILTER AND PSI READINGS

This was submitted on Monday. Told it was lost in the mix. Told to resubmit: “Hi Dave Light Your comment in the Support section was received. Thank you for posting the following question. FILTER PSI READINGS Pool installed last spring 2018. Aqua Tech cleaned water with their filters. Our brand new filters then installed. Initial… Read More»

POOL FILTER AND PSI READINGS

I already submitted a portal email on Monday to Support and told to resubmit again. “

Pool filter issue?

It seems like my Hayward sand filter works normally, except when I’m cleaning it. When I Backwash it for a couple minutes, it’s ok. Then I rinse it for a minute and it’s ok. Then when I move it back to filter, it spews a little sand out the jet. Looks like I’ve lost a… Read More»

Pump and Filter Operation–Sand Filter

Normal Operation Valve on suction is open Dial Valve indicator on filter Pump switch is on Whatever the pressure gauge reads after the filter has been backwashed will be the normal setting for your filter. When the pressure raises 5 lbs. above the normal pressure setting, the filter needs backwashing. Normal Setting: ______________ Backwash Setting:______________… Read More»

Pool sand filter

Can you please call me 204-637-3180 My sand filter seems to need backwashing far more often than is recommended. Thanks

How to Clean Your System 3 Pool Filter Cartridges

System 3:Modular Media Cleaning Procedure The modular media filter is designed for: 1) Low maintenance 2) Fine particle filtration 3) Cost savings   For best results, follow the steps below. Based on normal operation the filter element must be chemically cleaned once a year. To clean: a) Turn the pump off. b) Remove lid, and… Read More»

How to clean your sand filter

The sand in your pool filter should be chemically cleaned at least once a year to ensure proper pool operation. For best results, follow the steps below. a) Backwash filter for 3—5 minutes, rinse for 20 –30 seconds to remove the debris that can be rinsed off. b) Turn pump off and return dial valve… Read More»

sand filter pump

I bought a new sand filter pump, put new sand in. intake and discharge on pump and filter are 1 1/4″ lines. intake and discharge on pool is 1 1/2″ so I reduced it down to 1 1/4″. started up the pump and the pressure gauge goes to 8psi immediately. what do I do to… Read More»