Hi! I have had an error message “low amps – check cell” with my digital pool pilot by lectronator…sc36…for a few weeks. It was installed in june 2012. As it was still chlorinating the pool, and occasionally not sending an error message, I decided to just run the chlorinator high capacity and monitor it. It stopped chlorinating and the error message now is always on. I checked the manual…and checked and cleaned the cell. Checked and cleaned cable connections…I balanced the pool and brought down alkalinity with muriatic acid..and added some shock to get the chlorine level out…add stain prevent to remove minerals..rinsed the filters. And topped up the salt…now at 3000ppm. The next thing I did was run the pool pilot test…and checked the amps (27-28 amps) and volts (2.4). The manual said if the amps and volts were low then to check the fuses. Two of the fuses appear to be good…the main ac power and the panel board fuses are clear and I could see their filaments were intact…Fuse 3 the cell fuse is opaque. My next move is to remove it and go to see you about a replacement. Is there anything else I can try? I tried to reverse the flow …didn’t work. Please advise.
