Hot Tub heater

Asked by David Marshall

1 reply

Last Reply on June 15th, 2017 by Nigel

June 15, 2017

In response to your reply on June 14 re Chelsea hot tub:
How do I know if it the PWA is set up for 60amp logic?
How do I do the temp override?

Replies

  1. Nigel

    June 15, 2017

    Reply

    David visually check your jumper pin settings on the PWA. JP1 5-6 should be on and JP1 1-2 should be off for 60amp logic. These instructions can also be found on page 52 of your 780 Series Owners manual.
    Press and hold the warmer button then press and hold the Jets 1 button @ the same time for 2 seconds. You will see the temperature rise to 106. Once the temperature goes below 104 you will be required to repeat the steps above if you desire to raise the temperature to 106 again. These instructions can also be found on page 25 & 26 of your 780 Series Owners manual.

Ask a Question or Comment